![]() It finally gets amplified in the brown power amp. ![]() Signal then goes through a low-pass, a small equalizer and a compressor (the big purple box). The small green box on its left merges the left and right channels to forward it to the subwoofer section, which is the complete left half of this diagram (except the red box on the left, which is just power). In the middle yellow box there's some trebble/volume/bass control. The sound comes in on the right, in the green box. The block I want to short-circuit is the pink one on the left. My question is: should I disconnect the input and output from the compressor (in that case should I remove power supply as well, which would be very annoying), or can I leave it connected but short-circuited? Altec Lansing offers a myriad of speaker options, ranging from devices that just get the job done (the Baby Boom for 29. I will connect the input to the output so it gets forwarded to the next stage. Among Altec Lansing audio equipment are Altec Lansing speakers. ![]() Its active components are a JFET and four op-amps. I have an Altec Lansing ATP3 2.1 audio system PCB which I reverse-engineered, and I would like to bypass the JFET compressor that's on it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |